How to Fix a Broken Floor Board

Print this articleBroken floor boards on your deck or in your home require replacement to avoid injury and damage to the surrounding floor. Floor boards, unlike laminate, do not interlock on the sides, and that makes them less difficult to replace. However, it is necessary to purchase a replacement board that closely resembles the floor. Most standard floor boards are 3¼ inches wide and 1/2 inch thick. Replacement floor boards are available at home improvement centers and flooring dealers. Take a piece of the existing floor board to ensure you purchase a close match.

Related Searches:Difficulty:Moderately EasyInstructions Things You'll NeedMasking tape1/4-inch paddle bitDrillWood chiselHammerPry barTape measureHand sawSpiral flooring nailsNail setStain (optional)Suggest Edits1

Place masking tape on the floor boards surrounding the broken floor board. This protects the surrounding floor boards from damage when prying up the broken board.

2

Insert a 1/4-inch paddle bit into your drill. Drill two holes next to each other 2 inches from one end of the broken floorboard. Position the end of a wood chisel over the small space between the two holes. Tap the chisel with a hammer to cut through the board between the two holes.

3

Position a pry bar into the cut section of the broken floor board, and pry the board out of the floor. Remove the small portion left on the floor joist with the pry bar as well.

4

Hammer down any nails left in the joist from the removed floor board. Measure the length of the area for the new board with a tape measure.

5

Transfer the measurement to the new floor board and cut it with a hand saw. Fit the new floor board into the empty space. If necessary, sand down the edges with 220-grit sandpaper until the board fits snugly into the floor.

6

Drive spiral floor board nails into each end of the board and into the floor joist with a hammer, leaving the head of the nail slightly above the floor board surface.

7

Place a nail set over the head of the nail and tap the nail set with a hammer to drive the nail into the floor board, slightly countersinking the nail head. A nail set looks similar to a center punch.

8

Finish the new floor board with a matching stain, if you purchase an unstained replacement board.

Tips & Warnings

If replacing laminate floor boards, cut the broken board down the center with a circular saw and remove the pieces. Cut the bottom of the groove of the interlocking notch on one side to fit the board into the empty space.

Suggest item

ReferencesService Magic: Hardwood Floor RepairFine Homebuilding: Replacing a FloorboardRead Next:

Print this articleCommentsFollow eHowFollow

View the Original article